Redirect Cisco show commands

Short overview of how to redirect Cisco show commands… quite useful sometimes 😉

show <command> | redirect URL

The syntax to redirect the command output to the file location specified in the URL. The pipe (|) is required. Prefixes can be local file locations, like flash: or disk0:. Alternatively, you can specify network locations using the following:

ftp://username:[email protected]/directory/filename
tftp://location/directory/filename

Rcp: prefix is not supported.

Example: Redirect show tech-support

show tech-support | redirect tftp://10.1.1.100/show-tech_c2960s-01.txt

Please share!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.